You are here: 7. Mobile Applications > 7.1. Configuration > 7.1.2. Configuring PDA Hardware > 7.1.2.4. Intermec CN50 > Intermec CN50 Device Setup > Steps 1 to 3 - Initial Setup
Intermec CN50 Device Setup

 

Warning

If you are rebuilding an existing device, you must perform a clean boot on the device first. Refer to Clean Booting the CN50 under "Intermec CN50".

 

Steps 1 to 3 - Initial Setup

You can build a device from an out-of-the-box scenario for use in a Micronet environment. To do this:

  1. Power up the unit.

Ensure that the PDA has the battery installed and charged. Upon powering on the unit, a series of applications will run and install after boot-up. This takes approximately 5-10 minutes.  Please wait patiently until all orange boxes have stopped popping up on the screen.

  1. If the ITE program displays, it must be disabled.
  1. If required, setup RAMDISK.